3Com 3C17400 User Manual - Page 27
Removing an SFP Transceiver, Gigabit Ethernet connection.
View all 3Com 3C17400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Figure 5 Inserting a SFP Transceiver SFP Operation 27 Product label 21 22 23 24 Suitable port on host Switch 5 The transceiver connects to the network using a duplex SC connector. Attach a male duplex SC connector on the network cable into the duplex SC connector on the transceiver. 6 Connect the other end of the cable to a device fitted with an appropriate Gigabit Ethernet connection. 7 Check the Module Active LEDs on the front of the Switch to ensure that it is operating correctly. Refer to "LEDs" on page 16 for more information. Removing an SFP If you wish to remove the transceiver (it is not necessary to power-down Transceiver your Switch): 1 Disconnect the cable from the transceiver. 2 Move the wire release lever downwards until it is pointing toward you. 3 Pull the wire release lever toward you to release the catch mechanism; the transceiver will then easily slide out.