AIWA BMZ-K1 Operating Instructions - Page 8
ADJUSTMENTS BEFORE OPERATION, Setting the clock, Spectrum analyser display, Back light, Power - remote
View all AIWA BMZ-K1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
ADJUSTMENTS BEFORE OPERATION POWER POWER 6STANDBY/ON BAND DISPLAY SPECTRUM MODE MULTI JOG r BAND t r,t zEJECT ENTER CLOCK/TIMER SET ENTER DISPLAY DISC SELECT (1-5) SHIFT En Power Turning the unit on Press POWER 6STANDBY/ON (POWER on the remote ). Alternatively, press BAND, DISC SELECT (1-5). Playback will start automatically if a disc is loaded. ECO OFF: Power economizing mode is cancelled. When the unit turns off, the clock display appears. Initial mode is ECO OFF. Standby power consumption BMZ-K1 Turning the unit off Press POWER 6STANDBY/ON again. The unit goes into standby. ECO ON: 0.25 W ECO OFF: 20 W BMZ-K2 ECO ON: 0.25 W ECO mode ECO OFF: 24 W Reduces power consumption in standby mode with the following operations. Press MODE on the main unit when the unit is turned off. Each press of the button changes the mode as follows; ECO ON: Power economizing mode is activated. When the unit turns off, everything on the display clears and only the red indicator above POWER lights to show that the Setting the clock 1 Press CLOCK/TIMER SET on the remote. See below when to adjust the clock. 2 Press r or t to set the hour, then press ENTER. 3 Press r or t to set the minute. Each press changes the time in 1-minute steps. power is being supplied. 4 Press ENTER. The time display stops flashing and the clock starts from 00 seconds. •MULTI JOG is also available in place of r or t. To adjust the clock 1 Press CLOCK/TIMER SET on the remote. 2 Press r or t repeatedly to display "CLOCK" and then press ENTER. 3 Carry out steps 2 to 4 described in "Setting the clock" to set the time. To display the time while the power is on Press DISPLAY repeatedly. The clock display appears in the display for 6 seconds. If "- -:- -" appears when the unit is turned off There has been a power interruption. Reset the clock. Spectrum analyser display You can change the spectrum analyser display. 1 Press MODE repeatedly so that "PATTERN" is displayed, and then press ENTER. 2 Within 6 seconds, turn MULTI JOG to select one of the three spectrum analyser displays (PATTERN 1, 2 and 3). When using the remote, hold down SHIFT and press SPECTRUM repeatedly. Back light Turns the back light on and off. Press DISPLAY while the unit is turned off. The back light lights up and clock display appears in the display for 6 seconds. 8