AIWA CA-DW635 Operating Instructions - Page 17

TROUBLESHOOTING GUIDE F~ARTS INDEX If the unit fails to perform as described in these Operating Instructions, check the following guide. GENERAL There is no sound. q Is the AC cord connected properly? q Was an incorrect function button pressed? Power is not turned on. q Is the AC cord connected to the unit with old batteries inserted? ~ Remove all the batteries and disconnect the AC cord. Then, connect the AC cord again and reset the unit as stated below. An erroneous display or a malfunction occurs. + Reset the unit as stated below. TUNER SECTION The reception contains noise interferences or the sound is distorted. q Is the unit picking up external noise or multipath distortion? ~ Change the orientation of the antenna or the unit. ~ Move the unit away from other electrical appliances. CASSETTE DECK SECTION The tape does not run. q Is the deck in pause mode? (a page 10) The sound is off-balance or not adequately high. q Is the playback head dirty? (~ page 16) Recording is not possible. q Is the erasure prevention tab on the tape broken off? (~ page 1O) q Is the recording head dirty? (a page 16) Erasure is not possible. q Is the erasure head dirty? (~ page 16) q Is a metal tape or CrOz tape being used? High frequency sound is not emitted. q Is the recording/playback head dirty? (~ page 16) CD PLAYER SECTION The CD player does not play. s Is the disc correctly inserted? (~ page 8) q Is the disc dirty? (~ page 16) q Is the lens affected by condensation? ~ Wait approximately one hour and try again. For instructions on use, refer to the page number indicated. f------'[SPLAY I!3 POWER button @ FUNCTION buttons (CD ~, AUX ~, TUNER/BAND ~, TAPE o) s PRESET button ~ ~ ~ @ - CLEAR button ~ ~ II SET button ~ 0 @ @ - DOWN, w UP buttons @ ~ @ @ TUNER MODE/OSC, DUB SPEED button 0 @ SLEEP button @ TIMER button @ & OpEN/CLOSE button ~ VOLUME buttons @ QSURROUND button @ T-BASS button @ GRAPHIC EQUALIZER (ROCK, POP, JAZZ) @ PHONES jack @ MIC jack@ MIC VOL control @ Deck operation buttons (0, P, -, -, s/A, @@ DISPLAY button 0 EQ button @ MODE button ~ ~ @ O-9, +1 O buttons @ ~ ~ REPEAT button 0 BAND button O FUNCTION button @ 1[) @ Eluttons on the remote control with the same names as those cn the main unit can be used as well. To reset If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows. 1 Press POWER to turn off the power. 2 Press POWER while pressing s . Everything stored in memory after purchase is canceled. ENGLISH 17