AIWA CA-DW635 Operating Instructions - Page 6

MANUAL TUNING When an FM stereo broadcast contains noise Press TUNER MODE/OSC. MONO appears on the display, Noise is reduced, although reception is monaural. MODE on the remote control is also available. 1 2 TUNER MODE/ Osc 1 Press TUNER/BAND repeatedly to select the desired band. ~FM+AM~ When TUNER/BAND is pressed while the power is off, the power is turned on directly and the previously tuned station is received (Direct Play Function). When using the remote control, press BAND repeatedly while the power is on. 2 Press 44 DOWN or FF UP to select a station. Each time the button is pressed, the frequency changes. During FM stereo reception, STEREO is displayed. To restore stereo reception, press the button again. To change the AM tuning interval The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval. Press POWER while pressing TUNER/BAND. To reset the interval, repeat this procedure. When the AM tuning interval is changed, all preset stations (see PRESETTING STATIONS) are cleared. The preset stations have to be set again. I To search for a station quickly (Auto Search) Keep + DOWN or - UP pressed until the tuner starts searching for a station. After tuning in to a station, the search stops. To stop the Auto Search manually, press + DOWN or ~ UP. q The Auto Search may not stop at stations with very weak signals. For better reception FM Extend the FM antenna and orient it for the best reception. AM The AM antenna is inside the unit. Position the unit for the best reception. A a %, FM 6 ENGLISH