AIWA CX-NHMT75 Operating Instructions - Page 12
Presetting Stations, Manual Tuning
View all AIWA CX-NHMT75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
RADIO RECEPTION MANUAL TUNING PRESETTING STATIONS 1 Press TUNER/BAND repeatedly to select the desired band. FM AM When TUNER/BAND is pressed while the power is off, the power is turned on directly. 2 Press f DOWN or g UP to select a station. Each time the button is pressed, the frequency changes. When a station is received, "TUNE" is displayed for 2 seconds. During FM stereo reception, 1 is displayed. 1 TUNE The unit can store a total of 32 preset stations. When a station is stored, a preset number is assigned to the station. Use the preset number to tune in to a preset station directly. 1 Press TUNER/BAND to select a band, and press f DOWN or g UP to select a station. 2 Press a SET to store the station. A preset number beginning from 1 in consecutive order for each band is assigned to the station. Preset number To search for a station quickly (Auto Search) Keep f DOWN or g UP pressed until the frequency starts to change rapidly. After tuning in to a station, the search stops. To stop the Auto Search manually, press f DOWN or g UP. • The Auto Search may not stop at stations with very weak signals. When an FM stereo broadcast contains noise Press MONO TUNER on the remote control so that "MONO" appears on the display. Noise is reduced, although reception is monaural. To restore stereo reception, repeat the above so that "MONO" disappears. To change the AM tuning interval The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval. Press POWER while pressing TUNER/BAND. To reset the interval, repeat this procedure. When the AM tuning interval is changed, all preset stations are cleared. The preset stations have to be set again. 12 ENGLISH 3 Repeat steps 1 and 2. The next station will not be stored if a total of 32 preset stations for all the bands have already been stored. "FULL" is displayed if you attempt to store more than 32 preset stations. PRESET NUMBER TUNING Use the remote control to select the preset number directly. 1 Press TUNER BAND to select a band. 2 Press numbered buttons 0-9 and +10 to select a preset number. Example: To select preset number 20, press +10, +10 and 0. To select preset number 15, press +10 and 5. Selecting a preset number on the main unit Press TUNER/BAND to select a band. Then, press d repeatedly or turn MULTI JOG. Each time d is pressed, the next ascending number is selected. To clear a preset station Select the preset number of the station to be cleared. Then, press s CLEAR, and press a SET within 4 seconds. The preset numbers of all other stations in the band with higher numbers are also decreased by one.