AIWA CX-NHMT75 Operating Instructions - Page 17

RECORDING CD PLAYING RECORDING BASIC RECORDING This section explains how to record from the tuner, CD player, or external equipment. To stop recording, press s. To pause recording, press a. (Applicable when the source is TUNER, VIDEO/AUX/5.1CH or MD) To resume recording, press it again. To start recording with the remote control First press q REC/REC MUTE, and then press c/d within 2 seconds. Sound adjustment during recording The VOLUME control has no effect on recording, while the BBE affects recording. Preparation • Use Type I (normal) and Type II (high/CrO2) tapes for recording. • Set the tape to the point where recording will start. 1 Insert the tape to be recorded on into deck 2. Insert the tape with the side to be recorded on first facing out from the unit. 2 Press REV MODE to select the reverse mode. To record on one side only, select p. To record on both sides, select [ or ]. 3 Press function (TUNER/BAND,VIDEO/AUX/5.1CH, CD or MD) and prepare the source to be recorded. To record from a CD, press CD and load the disc(s). To record from a radio broadcast, press TUNER/BAND and tune in to a station. To record from a connected source, press VIDEO/AUX/5.1CH or MD. 4 Press w REC/REC MUTE to start recording. When recording from a connected source, start playback of the source. When recording an externally connected source via the VIDEO/ AUX or the MD jacks, the small dot near the "]" lights up continuously in the display if the input level is too high. In this case, stop recording and adjust the input level until the dot lights intermittently (page 28). INSERTING BLANK SPACES Insertion of 4-second blank spaces enables you to activate the Music Sensor function. (Applicable when the source is TUNER/ BAND, VIDEO/AUX/5.1CH or MD.) 1 Press w REC/REC MUTE during recording or while in recording pause mode. 4 on the display flashes for 4 seconds and 4-second blank space is made. Then, the deck enters the recording pause mode. 2 Press a to resume recording. To insert a blank space of less than 4 seconds, press w En REC/REC MUTE again while 4 is flashing. To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press w REC/REC MUTE again. Each time the button is pressed, a 4-second blank space is added. 4 When the selected function is CD, playback and recording start simultaneously. "Can't REC" is displayed if you attempt to record on a tape with the plastic tabs broken off. To erase a recording Make sure the microphone is not connected to this unit. Set the microphone volume and the echo level to OFF (page 23). 1 Insert the tape to be erased into deck 2 and press TAPE/ DECK 1/2 to display "TP 2". 2 Set the tape to the point where the erasure is to be started. 3 Set the reverse mode by pressing REV MODE. 4 Press w REC/REC MUTE to start the erasure. ENGLISH 17