Aastra 390 390 Screenphone User Guide - Page 4

Installation Installation Your Model 390 telephone can be installed on a desk or mounted on the wall. To use the phone's Call Waiting and Caller Identification capabilities, contact your local Service Provider for subscription details. Your Service Provider may call these services by different names. 1. Connect the handset cord Turn the telephone over and locate the handset jack marked . Insert one end of handset cord into the jack until it clicks into place. Then route the handset cord through the groove as shown in the illustration below. Attach the handset to the other end of the handset cord. 1 the slots marked . For a lower viewing angle, use the slots marked . Then rotate the stand towards the phone until it snaps into place (B). 3. Connect the cords If you attached the stand to install the phone on a desk, route both the phone cord and power adapter cord through the opening in the stand. Insert the phone cord into the slot on the back of the telephone marked until it clicks into place. Insert the power cord into the power jack marked . Note: You should connect the power adaptor to a surge protector or power bar. 4. Press the cords into grooves Press the cords into two of the grooves provided on the bottom the stand. This will allow the stand to sit flat on a desk surface. B A 2 Power Adaptor Stand Line grooves Handset groove 4 Handset cord Handset 2. Attach the stand If you plan to mount the phone on the wall, you do not need to attach the stand; skip this step. If you plan to use the phone on a desk, attach the stand by inserting the tabs on the stand (marked with ) into the slots on the bottom of the telephone (A). For a higher viewing angle, use 3 Phone cord 5. Install the phone If you have installed the stand and are using the phone on a desk: Simply turn the telephone over so it 4 Model 390 User Guide