Aastra OpenCom 130 User Guide - Page 73
Configuration, Con the S
View all Aastra OpenCom 130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
S2M Connector Module Configuration 7. Reconnect the OpenCom 130 / 150 to the power supply. 8. Configure the S2M module in the Configurator of the OpenCom 130 / 150 (refer to Configuration starting on page 76). Check the level 1 status with ref- erence to the LEDs on the module. None of the LEDs are illuminated before the S2M module has been configured. LED Display LED 1 (green) 2 (green) 3 (yellow) 4 (red) Meaning Synchronous (= ok) Blue alarm Remote alarm or out of sync (yellow alarm) Loss of signal (red alarm) 9. Pull out the mains plug of the OpenCom 130 / 150 again and close the housing. 10.Reconnect the OpenCom 130 / 150 to the power supply. 5.2 Configuration The menu item S2M appears in the Configurator, menu Telephony: Ports after installation of the S2M module. Configure the port in the input mask of this menu item. Further information on this can be found in the online help. 71