Acer Altos 600 Acer Altos 600 User's Guide - Page 38
Terminator Power Source from both, I2C buffer ID setting
View all Acer Altos 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
24 Chapter 2 System Tour Jumper Setting JP2 Short Open Function Terminator Power Source from both backplane and host Only from Host Connector CN1 CN2 CN3 CN4 CN5 JP1 JP3 JP4 JP5 S1 S2 S3 S4 S5 Slot1 Slot2 Slot3 Slot4 Slot5 Description For SAF-TE card use SCSI 68-pin P connector - Out SCSI 68-pin P connector - In Front power LED connector I2C Buffer connector I2C buffer ID setting Power connector1 Power connector 3-pin FAN connector Slot 1 ID switch2 Slot 2 ID switch Slot 3 ID switch Slot 4 ID switch Slot 5 ID switch SCSI slot 1 connector SCSI slot 2connector SCSI slot 3 connector SCSI slot 4 connector SCSI slot 5 connector 1 For the SCSI Backplane board's loading requirement, please insert an independent Power cable that doesn't connect to any other device into each power connector on the Backplane board. 2 When you use the LVD SCSI hot-swap cage to arrange your system hard drives, please remove all the jumpers on each SCSI hard drive and use the switches on the backplane board (S1~S5) to set the hard drive's ID.