Adaptec SC4100 User Guide - Page 22

Installing into an Equipment Rack, Use either the speednuts or cagenuts provided if

Get Adaptec SC4100 - 73GB 10K Rpm U320 SCSI HD PDF manuals and user guides
UPC - 760884147078
View all Adaptec SC4100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Installing the Storage Enclosure Installing into an Equipment Rack Begin the installation by ensuring that you have all these rail kit components: ■ Front rails (1 left, 1 right) ■ Rear rails, two different sizes (2 left, 2 right) ■ 20 nuts (10 each of two different types) ■ 4 small screws and 10 large screws To install your Storage Enclosure in an equipment rack: 1 Secure the front rails to the front supports of the rack, using the supplied screws, as shown in Figure 2-1. Note: Use either the speednuts or cagenuts provided if your rack does not have threaded holes. Figure 2-1 Securing the Rails to the Rack 2 Check the length between the front and rear supports of your equipment rack and determine which set of rear rails to use, the long or the short. 2-4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
2-4
Installing the Storage Enclosure
Installing into an Equipment Rack
Begin the installation by ensuring that you have all these rail kit
components:
■
Front rails (1 left, 1 right)
■
Rear rails, two different sizes (2 left, 2 right)
■
20 nuts (10 each of two different types)
■
4 small screws and 10 large screws
To install your Storage Enclosure in an equipment rack:
1
Secure the front rails to the front supports of the rack, using the
supplied screws, as shown in
Figure 2-1
.
Note:
Use either the speednuts or cagenuts provided if
your rack does not have threaded holes.
Figure 2-1
Securing the Rails to the Rack
2
Check the length between the front and rear supports of your
equipment rack and determine which set of rear rails to use, the
long or the short.