Adaptec SC4100 User Guide - Page 44
Installing an I/O Module (or I/O Blank
UPC - 760884147078
View all Adaptec SC4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Removing and Replacing Enclosure Components 2 Disconnect all the cables connected to the I/O module. 3 Loosen the two screws below the I/O module handles. 4 Gently push down on the handles to disengage the I/O module from the enclosure. 5 Using the handles, gently slide the I/O module out of the enclosure (shown at right). Installing an I/O Module (or I/O Blank) 1 Power off the host system and enclosure. ! Caution: I/O modules are not hot-swappable. You must power off the host system and enclosure before installing an I/O module or I/O blank. 2 Ensure that the handles of the new I/O module are lowered (open). Note: Do not use the handles to lift or carry the I/O module. 3 Gently push up on both handles simultaneously to fix the I/O module into place. 4 Secure the module by tightening the two screws you loosened in Step 3 on page 4-8. Hand-tighten the screws. Do not overtighten them. 5 Connect the I/O cables, as described in the chapter of this Guide that is dedicated to your specific Storage Enclosure's interface: ■ For a SATA interface (Adaptec FS4100 or FS4500), see Chapter 5. ■ For an FC interface (Adaptec FC4100), see Chapter 6. ■ For an Ultra320 SCSI interface (Adaptec SC4100), see Chapter 7. 4-8