Adaptec SC4100 User Guide - Page 39
Removing a Drive Carrier (or Carrier Blank), Warning, Caution
![]() |
UPC - 760884147078
View all Adaptec SC4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Removing and Replacing Enclosure Components Warning: If the Storage Enclosure is powered on, you must wait for the disk drive to power down and spin down fully to prevent disk drive damage and possible personal injury. ! Caution: Immediately replace the removed drive carrier or install a carrier blank to maintain correct airflow and cooling. Removing a Drive Carrier (or Carrier Blank) To remove a drive carrier or carrier blank: 1 Press on the button to release the cam lever (shown at right). 2 Gently pull open the cam lever. The carrier locking tabs disengage, releasing the drive carrier from the enclosure. 3 If the Storage Enclosure was powered on and you are removing a disk drive, allow the disk drive to spin down fully (approximately one minute). 4 Gently pull the drive carrier (or carrier blank) out of the enclosure. 5 Immediately replace the removed drive carrier or install a carrier blank to maintain correct airflow and cooling. For instructions on installing a drive carrier, see Step 3: Installing the Drive Carriers on page 2-9. 4-3
![](/manual_guide/products/adaptec-sc4100-user-guide-c19e9bb/39.png)