Adaptec SC4100 User Guide - Page 43
Replacing an I/O Module, Removing an I/O Module
UPC - 760884147078
View all Adaptec SC4100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Removing and Replacing Enclosure Components Replacing an I/O Module This section provides basic information about your Storage Enclosure's I/O modules, including removal and installation instructions. Two I/O modules are located on the rear of the Storage Enclosure, and they are interface-specific. A blank I/O module may also be available for single I/O module configurations. (For detailed information about your I/O modules, see the chapter dedicated to your specific interface: ■ For a SATA interface (Adaptec FS4100 or FS4500), see Chapter 5. ■ For an FC interface (Adaptec FC4100), see Chapter 6. ■ For an Ultra320 SCSI interface (Adaptec SC4100), see Chapter 7. To maintain proper airflow and cooling, either an I/O module or an I/O blank must be installed in both of the Storage Enclosure's I/O slots. ! Caution: The I/O modules on the SC4100 are not hotswappable. Do not attempt to hot-swap SCSI I/O modules. ! Caution: Although SATA and FC I/O modules are hotswappable, Adaptec highly recommends that you power off the Storage Enclosure before removing or installing any I/O module. Hot-swapping an I/O module may result in data loss or damage to the module and enclosure electronics. Removing an I/O Module To remove an I/O module from the Storage Enclosure: 1 Power off the host system and enclosure. ! Caution: Adaptec highly recommends that you power off the Storage Enclosure before removing or installing any SATA or FC I/O module. SCSI I/O modules are not hot-swappable. 4-7