Alcatel OS6850-U24X Getting Started Guide - Page 16

Booting OmniSwitch 6850 Series Switches Booting a Standalone Switch The OmniSwitch 6850 Series switch does not use an on/off switch. The power cord is the switch's only connect/disconnect device. The power connector socket is located on the switch's rear panel. For more information, refer to the OmniSwitch 6850 Series Hardware Users Guide. To boot the switch, plug the power cord (provided) into the power connector socket at the switch's rear panel. Next, plug the power cord into an easily-accessible power source, such as a grounded AC outlet or an Uninterruptible Power Supply (UPS). The switch immediately begins the boot process. Allow a few moments for the switch to boot completely, then verify the status of all LEDs on the switch's front panel. A successful boot for a standalone switch displays the following LED states: LED States for a Standalone Switch OK PRI PWR Solid green Solid green Solid green LED States for a Standalone Switch BPS XFP1 XFP2 Slot Indicator Solid amber, if BPS attached is failed; off, if no operational BPS is attached; solid green if an operational BPS is attached and operating normally. Off (applies to all OmniSwitch 6850 Series switches except for the OmniSwitch 6850-24X, OmniSwitch 6850-P24X, OmniSwitch 6850-48X, OmniSwitch 6850-P48X, and OmniSwitch 6850-U24X). Off (applies to all OmniSwitch 6850 Series switches except for the OmniSwitch 6850-24X, OmniSwitch 6850-P24X, OmniSwitch 6850-48X, OmniSwitch 6850-P48X, and OmniSwitch 6850-U24X). 1-8 (non-blinking), depending on the slot number value in the boot.slot.cfg file. See the OmniSwitch 6850 Series Hardware Users Guide for detailed information. The default value is 1. 12 Booting OmniSwitch 6850 Series Switches June 2007