Alpine PXE-0850S Owners Manual - Page 15
Set Sound Volume and Phase, Position of Output Channel, Select Type of Output Channel, Set Delay
View all Alpine PXE-0850S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Software for PC Linkwitz-Riley, Bessel and Butterworth options. Frequency setting: Adjust low-pass or high-pass frequency by directly entering the value, scrolling mouse wheel or pressing up/down arrow keys. Range of adjustment: 20Hz~20KHz. Frequency slope (Slop) setting: Drop-down menu has 8 options: 12dB/Oct, 18dB/Oct, 24dB/Oct, 30dB/ Oct, 36dB/Oct, 42dB/Oct, 48dB/Oct and close. Select Type of Output Channel 1. Select output signal channel types. Set Sound Volume and Phase Position of Output Channel 1. The editing and display panel for output channel sound volume, low-pitched phase position, phase EQ, phase position editing and displaying panel. types. Such as pre-three-modulus crossover and post-dual-crossover; 5.1 System; 7.1 System etc. In the positive phase position, a. Click [Reset]: Clear or restore default output setting. In the inverted phase position a. Channel sound volume: Adjust the channel volume by directly scrolling the volume fader, or entering the value or scrolling mouse wheel. The range of adjustment: Close -59dB ~ 0dB. b. Mute button: Click [ ] to mute the channel sound volume and click again to cancel the mute (mute will be automatically canceled when adjusting the channel sound volume). c. Click [Positive Phase] to change output phase position: positive or inverted. d. Low-pitched phase position and phase EQ: Adjust the phase by directly entering the value, scrolling mouse wheel or pressing up/down arrow keys. The range of low-pitched phase: 0° ~ 360°. The range of phase position EQ: 20Hz~20KHz. Low-pitched phase position could set 20Hz-200Hz frequency bands adjustable at 0-360°, with a resolution of 2°. Phase position EQ could rotate 180° of nearby frequency point's signal phase position. 14 b. Click [Combined Tuning] to tune the left and right channel. You need to select the method for data synchronization before combined tuning. c. Click [EQ] or [Sound Source Mixing] to enter the tuning interface. Set Delay 1. Output signal delay panel. a. Delay: Adjust by directly entering the value, scrolling mouse wheel or pressing up/down arrow keys. b. Delay unit: Drop-down menu, the default unit of delay is [Millisecond] and either [cm] or [inch] is also available for selection.