Alpine PXE-H650 User Guide - Page 13

BASIC OPERATION NOTE: Press the "RESET" button on the main chassis, any time during the calibration process, to return to the Main Menu. From the Main Menu, four options are available. • RECALIBRATE MULTEQ: Press ENTER at this display to clear the previous MultEQ settings. The current levels and AntEQ settings are not changed. • CLEAR SETTINGS: Press ENTER at this display to clear all Customization settings. This returns the processor to the last MultEQ baseline response. • FACTORY RESET: Press ENTER at this display to return the PXE-H650 to its original factory condition. The entire calibration procedure must be redone. • CANCEL: Press ENTER at this display to return to PXE-H650 STANDBY mode. Demo Mode Overview E N • Demo mode will allow the user to audition MultEQ/AntEQ ON and OFF with the press of a single button on the remote control. Demo Mode • Press the MODE button once on the PXE-H650 to reach the Demo mode screen on the LCD. Press the "ENTER" button once to enter the Demo mode. At this time, "DEMO MODE ON" appears in the display. Press the Fader "REAR" button to turn OFF MultEQ/ AntEQ, while pressing the Fader "FRONT" button turns MultEQ/AntEQ ON. • While in the Demo mode, all remote controller buttons are locked out except: Volume UP, Volume DOWN, HU and AUX source switch buttons, and MUTE (if AUX PRIMARY SOURCE switch is ON then HU source switch button is also locked out). • Press the "ENTER" button again to turn off the Demo mode and resume normal operation. At this time, "DEMO MODE OFF" appears in the display. 15