Alpine X409-WRA-JK Installation Manual EN - Page 9

Jeep Wrangler X409-WRA-JK 20201016v1 ˜ 9/21 Installation Instructions DISCONNECT THE BATTERY BEFORE CONTINUING. FAILURE TO DO SO WILL DISABLE MANY FEATURES. 1 Attach the modified panel using the factory screws. 2 Put monitor face down on a soft, scratch free surface and attach Display Monitor Brackets using (4) 8mm screws (provided). Plug in the Display Cable and Display Power Harness. 3 Apply Insulating pad by removing the paper backing. See diagram below. 4 Attach the display and source unit with the 8mm screws (supplied) as shown below. Route the display cable and power harness from the display to the source unit and plug into the W. Remote and Display Out. 5 Route the USB extension cable to the glove box or center console area. This is what will be used to plug in the phone for CarPlay and Android Auto. Connect the main harness and other adapters to the factory harness and secure them. 6 Route the key harness through the top-left side of the X409 source unit. Mount the X409 source unit using (4) 7mm factory screws.