Amana ART318FFDW Installation Instructions - Page 15

Refer to the side diagram for the following steps. 1. Take the two jumper harnesses included in the kit and determine which one can connect to the freezer wiring harness. Discard the other jumper. 2. Connect the compatible jumper harness to the ice maker wiring harness. Route the wires over the guide and through the wire clip in the ice maker. 3. Position the ice maker inside the freezer compartment and connect its wiring connector to the jumper harness connector so they lock together. The connectors will fit together only one way. 4. For Top/Upright Freezers Only: Hang the ice maker over the two hex-head screws you installed earlier. Make sure that the bottom mounting bracket hole is aligned with the mounting hole in the freezer liner, then tighten the two top hex head screws. Be sure not to overtighten the screws. 5. For Side-By-Side Models Only: Position the ice maker so that its top and bottom mounting tabs are flat against the side of the freezer liner. Center the top tabs under the two mounting clips, and push the ice maker straight up so that the mounting clips snap over the tabs and lock into place (you should hear them "click" as they lock). 6. Mount the bottom bracket of the ice maker to the freezer liner mounting hole with a 1/2" hex-head sheet-metal screw. 7. Confirm fill tube extension reaches into the fill cup on the ice maker. Install a different extension from the kit if the one previously selected is too long or too short to dispense into the fill cup with the ice maker mounted. WCWliiirpree Clip GuGidueide Screws Tabs Bottom mounting bracket 1/2" hex-head sheet metal screws Mounting the ice maker (top and upright freezers) Ice maker Slide tabs under clip Insert fill tube into cup Bottom mounting bracket 1/2" hex-head sheet metal screws Mounting the ice maker (side-by-side models) 15