Amana ART318FFDW Installation Instructions - Page 7
Side-by-side models
View all Amana ART318FFDW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Side-by-side models Refer to the side diagram for the following steps. You will be working inside the freezer compartment. 1. Remove the screw from the ice maker wiring cover and remove the cover. 2. Refer to DETAIL A, and with a pair of pliers, break away the tabs from the wiring cover and discard them. 3. Insert the blade of a small screwdriver under the edge of the round hole plug for the fill tube, (located at the back of the freezer liner), and pry it out. You can discard the plug. Insert pin into hole Hole Pin Wiring harness DETAIL A Wiring cover Hole cover Slot Screw Insert tab into slot Tab Refer to the side diagram for the following steps. You will be working on the outside at the rear of the cabinet. 1. In the upper right corner of the cabinet, peel off the label that is over the fill tube hole. 2. Pull the foam insert out of the fill tube hole and discard it. Break off and discard Ice maker wiring cover Remove this label for Ice Maker installation Foam insert Label Removing the label and foam plug Refer to the side diagram for the following steps. 1. Locate the fill tube and the round foam gasket from the ice maker kit (the gasket may already be installed on the fill tube). If not already done, slide the gasket over the end of the fill tube. 2. Insert the fill tube through the hole in the rear of the refrigerator with the spout facing down, and secure it with two 1/2" hex-head sheet metal screws. 1/2" hexhead sheetmetal screws Spout Spout Fill tube Foam gasket Installing the fill tube/gasket 7