Asus AP6000 Hardware Reference - Page 19

II. System Components Hot-Swap Tray Usage Each hot-swap tray provides an aluminum carrier for a single SCSI hard disk drives with a maximum height of 1 5/8 inch, width of 4 inches, and length of 6 inches. The aluminum tray provides protection and maximum heat dissipation for almost all types of high speed SCSI disk drives. The provided cables and wires connect to the SCSI hard disk drive and screws are needed to secure the tray to the bottom of the SCSI hard disk drive. Power Connector SCSI ID SCSI Cable Aluminum Tray Activity LED (ALED) II. Components Hot-Swap Trays Hot-swap tray and its connectors Hot-Swap Tray Front Connections The hot-swap tray provides wires for connecting the activity LED, power LED, SCSI ID, power, and SCSI signal. Connect the 8 pin connector to the SCSI Address pins according to the colors shown. Connect the 2 pin connector to the activity signal pins according to the colors shown. IMPORTANT: The following is only an example. Always consult your hard disk drive documentation or labels for the exact wiring specific to your hard disk drive make and model. Seagate Cheetah (ST34501W) side opposite power & SCSI Red White Green Orange Brown Unused 8 4 2 1 Black Activity Signal Blue Yellow Red Black SCSI Address (ID#) Pin 1 Pin 2 Hot-swap tray SCSI ID & activity LED wires connected (Seagate HD) AP6000 Hardware Reference Guide 19