Asus AP6000 Hardware Reference - Page 23
SCSI ID Setting, SCSI ID Dip Switches
View all Asus AP6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
II. Components SCSI ID II. System Components SCSI ID Setting SCSI ID settings are made through DIP switches located on the SCSI board. Each SCSI board IDSEL switch has default settings as labeled below. The default settings were set for use with a 2-channel SCSI card. Each channel may repeat the SCSI ID numbers of another channel. Make sure that each IDSEL switch (on each channel) has its own unique setting if making changes to these switches. See next page for more information on SCSI ID settings. Notch Out (top) 68pin Wide SCSI Connector SCSI Board Power IDSEL0 IDSEL1 SCSI ID Switches IDSEL2 IDSEL3 Notch In (bottom) SCSI Board back side SCSI ID Dip Switches The following illustrates the different possibilities using the dip switches. ON IDSEL0 Default ON ON ON Setting for SCSI ID #0 Setting for SCSI ID #4 Setting for SCSI ID #8 Setting for SCSI ID #12 ON IDSEL1 Default ON ON ON Setting for SCSI ID #1 Setting for SCSI ID #5 Setting for SCSI ID #9 Setting for SCSI ID #13 ON IDSEL2 Default ON ON ON Setting for SCSI ID #2 Setting for SCSI ID #6 Setting for SCSI ID #10 Setting for SCSI ID #14 ON IDSEL3 Default ON ON ON Setting for SCSI ID #3 Setting for SCSI ID #7 Setting for SCSI ID #11 Setting for SCSI ID #15 AP6000 Hardware Reference Guide 23