Asus AW1500-S5 AW1500-I5 English Manual - Page 51

Removing Power Supply Case

Get Asus AW1500-S5 PDF manuals and user guides View all Asus AW1500-S5 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 51 highlights

Removing Power Supply Case The power supply module is secured in a power supply cradle that connects to various power supply connectors on the SCSI backplane, the motherboard, IDE, floppy and CD-ROM drives. To remove the power supply, follow these steps: Make sure that the power suppy cable is unplugged before performing this procedure. 1. Remove the six (6) chassis bar screws to release chassis bar. 2. Disconnect all power cables connected to the floppy disk drive, the CDROM drive(s), the IDE drive(s), the ATX power connected to motherboard and SCSI backplane. Make sure all power cable connections are disconnected before proceeding to next step. 3. Remove the four (4) screws that secures the power case to the chassis. 4. Push power case into chassis to release power case from cradle, then pull-out case from the side of the chassis. Take caution when pulling-out the power supply case, the power case may accidentally drop and cause damage to the other components of the system. User's Manual A-5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
User’s Manual
A-5
Removing Power Supply Case
The power supply module is secured in a power supply cradle that
connects to various power supply connectors on the SCSI backplane, the
motherboard, IDE, floppy and CD-ROM drives.
To remove the power supply, follow these steps:
3.
Remove the four (4) screws that
secures the power case to the
chassis.
1.
Remove the six (6) chassis bar screws to release chassis bar.
2.
Disconnect all power cables connected to the floppy disk drive, the CD-
ROM drive(s), the IDE drive(s), the ATX power connected to motherboard
and SCSI backplane. Make sure all power cable connections are
disconnected before proceeding to next step.
4.
Push power case into chassis
to release power case from
cradle, then pull-out case from
the side of the chassis.
Take caution when pulling-out the power supply case, the
power case may accidentally drop and cause damage to
the other components of the system.
Make sure that the power suppy cable is unplugged before
performing this procedure.