Asus COMMANDO Commando User's Manual for English Edtion - Page 53
Serial ATA hard disk drive connection
View all Asus COMMANDO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
• You must install Windows® 2000 Service Pack 4 or the Windows® XP Service Pack 1 before using Serial ATA hard disk drives. The Serial ATA RAID feature (RAID 0/RAID 1/RAID 5/RAID 10) is available only if you are using Windows® 2000/XP or later version. • When using the connectors in Standard IDE mode, connect the primary (boot) hard disk drive to the SATA1/2/5/6 connector. Refer to the table below for the recommended SATA hard disk drive connections. Serial ATA hard disk drive connection Connector SATA 1/2/5/6 SATA 3/4 Setting Master Slave Use Boot disk Data disk Connect the right-angle side of SATA signal cable to the SATA device, or connect the right‑angle side of the SATA cable to the onboard SATA port to avoid mechanical conflict with huge graphics cards. right angle side 4. USB connectors (10-1 pin USB56, USB78, USB910) These connectors are for USB 2.0 ports. Connect the USB module cable to any of these connectors, then install the module to a slot opening at the back of the system chassis. These USB connectors comply with USB 2.0 specification that supports up to 480 Mbps connection speed. NC GND USB_P8+ USB_P8USB+5V NC GND USB_P6+ USB_P6USB+5V NC GND USB_P10+ USB_P10USB+5V ® COMMANDO USB910 USB56 USB78 1 1 1 GND USB_P7+ USB_P7USB+5V GND USB_P5+ USB_P5USB+5V GND USB_P9+ USB_P9USB+5V COMMANDO USB 2.0 connectors You can connect the USB cable to ASUS Q-Connector (USB, blue) first, and then install the Q-Connector (USB) to the USB connector onboard. ASUS Commando 2-29