Asus CUWE-RM CUWE-RM User Manual - Page 41
ASUS CUWE-RM User's Manual, ATX Power Supply Connector, pin block ATXPWR, Power Supply Thermal
View all Asus CUWE-RM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
3. H/W SETUP Connectors 3. HARDWARE SETUP 23) ATX Power Supply Connector (20-pin block ATXPWR) This connector connects to an ATX power supply. The plug from the power supply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned. IMPORTANT: Make sure that your ATX power supply can supply at least 10mA on the +5-volt standby lead (+5VSB). You may experience difficulty in powering ON your system if your power supply cannot support the load. For WakeOn-LAN support, your ATX power supply must supply at least 720mA +5VSB. CUWE-RM ® +3.3 Volts -12.0 Volts Ground Power Supply On Ground Ground Ground -5.0 Volts +5.0 Volts +5.0 Volts CUWE-RM ATX Power Connector +3.3 Volts +3.3 Volts Ground +5.0 Volts Ground +5.0 Volts Ground Power Good +5V Standby +12.0 Volts 24) Power Supply Thermal Sensor Connector (2-pin block JTPWR) If you have a power supply with thermal monitoring, connect its thermal sensor cable to this connector. CUWE-RM ® JTPWR Power Supply Thermal Sensor CUWE-RM Thermal Sensor Connector ASUS CUWE-RM User's Manual 41