Asus P I-P6NP5 User Manual - Page 13
Jumper Settings
View all Asus P I-P6NP5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
III. INSTALLATION (Jumpers) III. INSTALLATION Jumper Settings 1. On-Board Multi-I/O Selection (JP10) You can disable the onboard Multi-I/O (floppy, serial, parallel, and IrDA) through BIOS or entirely with the following jumper in order to use your own Multi-I/O card. Selections Enable Disable JP10 [1-2] (Default) [2-3] JP10 JP10 1 2 3 Enable (Default) Disabled Multi I/O Setting (Enable / Disable) 2. Flash ROM Boot Block Programming (JP13) This sets the operation mode of the boot block area of the BIOS Flash ROM to allow programming in the Enabled position. Programming JP13 Enabled [2-3] (Default) Disabled [1-2] JP13 JP13 Enable (Default) 1 2 3 Disabled Boot Block Programming (Disable / Enable) P/I-P6NP5 User's Manual 7
P/I-P6NP5 User's Manual
7
III. INSTALLATION
Jumper Settings
1.
On-Board Multi-I/O Selection (JP10)
You can disable the onboard Multi-I/O (floppy, serial, parallel, and IrDA)
through BIOS
or entirely
with the following jumper in order to use your
own Multi-I/O card.
Selections
JP10
Enable
[1-2] (Default)
Disable
[2-3]
1
Multi I/O Setting (Enable / Disable)
2
3
Enable (Default)
Disabled
JP10
JP10
2.
Flash ROM Boot Block Programming (JP13)
This sets the operation mode of the boot block area of the BIOS Flash
ROM to allow programming in the
Enabled
position.
Pr
ogramming
JP13
Enabled
[2-3]
(Default)
Disabled
[1-2]
Boot Block Programming (Disable / Enable)
Enable (Default)
JP13
1
2
3
JP13
Disabled
III.
INSTALLATION
(Jumpers)