Asus P4B-LS Motherboard DIY Troubleshooting Guide - Page 36

2.6.2 Configuring an expansion card After physically installing the expansion card, configure the card by adjusting the software settings. 1. Turn on the system and change the necessary BIOS settings, if any. See Chapter 4 for information on BIOS setup. 2. Assign an IRQ to the card. Refer to the tables below. 3. Install the software drivers for the expansion card. Standard Interrupt Assignments IRQ Priority Standard Function 0 1 System Timer 1 2 Keyboard Controller 2 N/A Programmable Interrupt 3* 11 Communications Port (COM2) 4* 12 Communications Port (COM1) 5* 13 Sound Card (sometimes LPT2) 6 14 Floppy Disk Controller 7* 15 Printer Port (LPT1) 8 3 System CMOS/Real Time Clock 9* 4 ACPI Mode when used 10* 5 IRQ Holder for PCI Steering 11* 6 IRQ Holder for PCI Steering 12* 7 PS/2 Compatible Mouse Port 13 8 Numeric Data Processor 14* 9 Primary IDE Channel 15* 10 Secondary IDE Channel *These IRQs are usually available for ISA or PCI devices. IRQ assignments for this motherboard A PCI slot 1 - PCI slot 2 - PCI slot 3 - PCI slot 4 - PCI slot 5 (LAN/SCSI slot) - PCI slot 6 - Onboard USB controller HC0 - Onboard USB controller HC1 - AGP used CNR LAN - CNR Audio/Modem - Onboard Audio - B used - C - - - - - used - - - - - - D E F G H - - shared - - - - - shared - - - - - shared - shared - - - - shared shared shared - ----- used - - - - - - - - shared ----- - shared - - - ----- - - shared - - When using PCI cards on shared slots, ensure that the drivers support "Share IRQ" or that the cards do not need IRQ assignments. Otherwise, conflicts will arise between the two PCI groups, making the system unstable and the card inoperable. 2-14 Chapter 2: Hardware information