Asus P4B-LS Motherboard DIY Troubleshooting Guide - Page 84
I/O Device Configuration
View all Asus P4B-LS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
4.4.2 I/O Device Configuration (Scroll down to see the last item as shown) Floppy Disk Access Control [R/W] When set to [Read Only], this parameter protects files from being copied to floppy disks by allowing reads from, but not writes to, the floppy disk drive. The default setting [R/W] allows both reads and writes. Configuration options: [R/W] [Read Only] Onboard Serial Port 1 [3F8H/IRQ4] Onboard Serial Port 2 [2F8H/IRQ3] These fields allow you to set the addresses for the onboard serial connectors. Serial Port 1 and Serial Port 2 must have different addresses. Configuration options: [3F8H/IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/ IRQ10] [Disabled] UART2 Use As [COM Port] This field allows you to select the device on which to assign UART2. Configuration options: [COM Port] [IR] [Smart Card Reader] Onboard Parallel Port [378H/IRQ7] This field sets the address of the onboard parallel port connector. If you disable this field, the Parallel Port Mode and ECP DMA Select configurations are not available. Configuration options: [Disabled] [378H/ IRQ7] [278H/IRQ5] 4-20 Chapter 4: BIOS Setup