Asus P5N-D User Manual - Page 54
IEEE 1394a port connector 10-1 pin IE1394_2, Chassis intrusion connector 4-1 pin CHASSIS
UPC - 610839159123
View all Asus P5N-D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
® P5N-D TPA1+ GND TPB1+ +12V TPA1GND TPB1+12V GND 5. IEEE 1394a port connector (10-1 pin IE1394_2) This connector is for a IEEE 1394a port. Connect the IEEE 1394a module cable to this connector, then install the module to a slot opening at the back of the system chassis. PIN 1 IE1394_2 P5N-D IEEE 1394a connector Never connect a USB cable to the IEEE 1394a connector. Doing so will damage the motherboard! You can connect the 1394 cable to ASUS Q-Connector (1394, red) first, and then install the Q-Connector (1394) to the 1394 connector onboard. The IEEE 1394a module cable is purchased separately. 6. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default , the pin labeled "Chassis Signal" and " Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. ® P5N-D +5VSB_MB Chassis Signal GND CHASSIS P5N-D Chassis intrusion connector (Default) 2-30 Chapter 2: Hardware information