Asus SP97 User Manual - Page 31

III. INSTALLATION (Connectors) R R III. INSTALLATION 16. AT Power Supply Connector (POWER, 12-pin block) This connector connects to a standard 5-volt power supply. To connect the leads from the power supply, ensure first that the power supply is not plugged. Most power supplies provide two plugs (P8 and P9), each containing six wires, two of which are black. Orient the connectors so that the black wires are together. PG +12V GND +5V ORG RED YLW BLU BLK BLK BLK BLK WHT RED RED RED P8 P9 +5V -12V -5V AT Power Connector Power Connector on Motherboard Power Plugs from Power Supply Using a slight angle, align the plastic guide pins on the lead to their receptacles on the connector. Once aligned, press the lead onto the connector until the lead locks into place. 17. ATX Power Supply Connector (ATXPWR, 20-pin block) This connector connects to an ATX power supply. The plug from the power supply will only insert in one way because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned. IMPORTANT: Make sure that the ATX power supply can take at least 10mA load on the 5-volt standby lead (5VSB). You may experience difficulty in powering on your system if your power supply cannot support the load. 3.3V - 12.0V - GND - PS-ON - GND - GND - GND - 5.0V - 5.0V - 5.0V - - 3.3V - 3.3V - GND - 5.0V - GND - 5.0V - GND - PW-OK - 5VSB - 12.0V ATX Power Connector ASUS SP97 / SP97-V User's Manual 31