Asus STRIKER II NSE User Manual - Page 63
Chassis intrusion connector 4-1 pin CHASSIS, Digital audio connector 4-1 pin SPDIF_OUT for ASUS HDMI
UPC - 610839160617
View all Asus STRIKER II NSE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
8. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. +5VSB_MB Chassis Signal GND STRIKER II EXTREME CHASSIS STRIKER II EXTREME/ STRIKER II NSE Chassis intrusion connector 9. Digital audio connector (4-1 pin SPDIF_OUT for ASUS HDMI VGA card) This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port(s). If you are using an ASUS HDMI-equipped graphics card, connect the HDMI card to this connector with a S/PDIF Out cable. +5V SPDIFOUT GND STRIKER II EXTREME SPDIF_OUT STRIKER II EXTREME/ STRIKER II NSE Digital audio connector The ASUS HDMI-equipped graphics card and the S/PDIF Out cable are purchased separately. ROG Striker II Extreme / Striker II NSE 2-37