Asus TS300-E5 User Guide - Page 166
Viewing Drive Assignments
UPC - 610839652525
View all Asus TS300-E5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
6.4.4 Viewing Drive Assignments From the Main Menu screen, press 1 to see the View Drive Assignments screen. The View Drive Assignments screen reports physical (disk) drive assignments and provides the following information: Channel: ID - Shows the FastTrak Controller channel (port) ID number to which each physical drive is attached. Drive Model - Identifies the manufacturer, model, and model number (if applicable) of each physical drive. Capabilities - Refers to the type of physical drive, SAS or SATA, and the drive's data rate in Gb/s. Capacity (MB) - Reflects the capacity in MB (megabytes) of the physical drive. The effective capacity of the physical drive is slightly smaller than its maximum rated capacity. Assignment - This field identifies the logical drive to which the physical drive belongs. LD 1-2 means logical drive 1, physical drive 2. JBOD also appears as LD on this screen. Unassigned physical drives are labeled Free. Unassigned drives may also be used to create a new logical drive at any time. Extent - Refers to the all or part of the physical drive's capacity allocated to a logical drive. If you create two logical drives using the same set of physical drives, each physical drive will display two Extents. 6-48 Chapter 6: RAID configuration