Belkin F1UP0301 F1UP0301 Manual - Page 17
Web Configuration - install
View all Belkin F1UP0301 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
section Web Configuration 1 Accessing the Web Configuration Menus 2 1. Connect the included Ethernet cable into the Print Server and to an available Ethernet port on your router or switch. 3 2. Power up the Print Server. Allow approximately one minute for the Print Server to boot and obtain an IP address. 3. Determine the Print Server's IP address, using one of the 4 following methods: a) New Print Servers are configured to receive IP addresses 5 dynamically. If your network has a DHCP server, the Print Server will obtain an IP address from your network. If the DHCP server 6 supports a client list, the client list will list the IP address assigned to the Print Server. If a DHCP server is not available, after 1.5 minutes the Print Server will revert to 192.168.2.253. 7 b) If the Print Server has been configured previously, then it will have been set to a static IP address that could be different for 8 every network. Note: Restoring factory defaults on the Print Server by holding in 9 the reset button for 10 seconds while repowering the Print Server will restore the IP address to dynamic. 10 c) Run the program "PSF.exe" from the Installation CD. This will find the IP address and link automatically to the web-based management interface. d) Go to the last step of the Print Server Installation Wizard, which has an Advanced button that finds the IP address and links automatically to the web-based management interface. 15