Beretta Cx4 Storm Beretta CX4 Storm User Manual - Page 22

Fig. 10, Fig. 11, Fig. 12, WARNING, Fig. 13 - disassembly

Get Beretta Cx4 Storm PDF manuals and user guides View all Beretta Cx4 Storm manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

• Slide the front part of the carbine (receiver/barrel assembly) from the stock. (Fig. 10) • Fully retract the cocking handle until it corresponds with the opening (circular part) of the port. (Fig. 11) • Remove the cocking handle by pulling it forcefully. (Fig. 12) ! WARNING: At this stage, the bolt is not blocked into position by the cocking handle and could therefore fall out. Handle with care all disassembled parts. • Remove the bolt from the barrel. (Fig. 13) Look down the barrel from the muzzle (or front) end so that you can see completely through the barrel to make sure no obstruction exists. If an obstruction in the barrel is detected, a qualified gunsmith must remove the obstruction and inspect the carbine before it can be fired. ! WARNING: If another cartridge is fired into an obstructed barrel, a catastrophic failure can result. 64

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
64
•Slide the front part of the carbine (receiver/barrel assembly)
from the stock.
(Fig. 10)
• Fully retract the cocking handle until
it corresponds with the
opening (circular part) of the port.
(Fig. 11)
•Remove the cocking handle by pulling it forcefully.
(Fig. 12)
WARNING:
At this stage, the bolt is not blocked into position by
the cocking handle and could therefore fall out.
Handle with care
all disassembled parts.
•Remove the bolt from the barrel.
(Fig. 13)
Look down the barrel from the muzzle (or front) end so that you
can see completely through the barrel to make sure no
obstruction exists.
If an obstruction in the barrel is detected, a qualified gunsmith
must remove the obstruction and inspect the carbine before it
can be fired.
WARNING:
If another cartridge is fired into an obstructed barrel,
a catastrophic failure can result.
!
!