Biostar TPOWER N750 Setup Manual - Page 24
Front view, Side view
View all Biostar TPOWER N750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Motherboard Manual PEX16-1 PEX16-2 Notice: Make sure both the graphics cards are seated into slots completely. Step 5: Connect a 4-pin ATX power cable to PEX power connector (PCIEX12V_CON1), this will ensure the stabilization of your system. Notice: When under SLI mode, please make sure the power supply is at least 500W or above. Step 6: Insert the SLI Bridge connector on the gold-fingers on each graphics card. Front view Side view Gold-fingers on two graphic cards Step 7: To securely fix the connector between two graphics cards, a retention bracket must be installed. Step 7-1: Remove any of the bracket cover between the two graphics cards. Step 7-2: Align and insert the retention bracket into the slot and then fix it with a screw. Notice: 1. Make sure the retention bracket supports the SLI Bridge firmly. 2. Retention bracket is optional 22