Bissell ProHeat 2X Upright Carpet Cleaner 1383 User Guide - Page 14
performing maintenance or troubleshooting checks.
View all Bissell ProHeat 2X Upright Carpet Cleaner 1383 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Maintenance & Care 5. Before you place the cleaned 2-in-1 water tank back onto the machine, remove the red solution filter cap (on the base of the machine). Remove the cap by inserting a coin or a flat head screw driver into the slot on the top. Turn counter clock wise and unscrew. Set aside. a. Remove the white filter by grasping the post and pulling up and out of the unit. Rinse the filter under cold water. Note: Be careful not to drop the filter into the sink or disposal. WARNING To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. Solution 5a. Filter Cap 5b. b. Replace the white filter back into the filter area. Note: Make sure the white filter is seated properly before placing the red solution filter cap. c. Replace the red solution filter cap and turn clockwise to tighten. 6. Keeping the 2-in-1 water tank off of the base 5c. of the machine, simply unscrew the floor nozzle 6. using a Phillips head screwdriver. This can be rinsed out at the faucet. Then replace back onto the machine by starting from the bottom of the nozzle and hooking the tabs into the holes on the bottom sides of the machine. Secure into Filter place with the screw. 7. The inside of the end caps by the brush rolls can be wiped out with a clean paper towel, or, if a more thorough cleaning is desired, the end caps can be taken off using a Phillips head screwdriver and rinsed clean. Replace after cleaning. 8. Any loose hair or debris can be pulled from the brush rolls and thrown away. For the most thorough clean before storage, follow directions for removal and replacement of the brush rolls and belts. 9. To clean attachments that may have been used, remove from hose and rinse under clean, running water. Dry and replace attachment in the tool caddy. Clean the hose by suctioning clean water from the tap. Before replacing, lift end of hose and stretch out to ensure all water is cleared from hose. Refer to page 10. 10. After carpet is dry, vacuum again to remove hair and fuzz. www.bissell.com 14 800.237.7691