Bissell ProHeat 2X Upright Carpet Cleaner 1383 User Guide - Page 8
Caution: Do not overwet.
View all Bissell ProHeat 2X Upright Carpet Cleaner 1383 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Operations 2. Set ReadyTools Dial to the floor cleaning 2. setting. 3. Plug into a proper outlet and turn the power and heater switches to the ON ( I ) position. Allow 1 minute for the built-in heater to warm-up before cleaning. The PROheat 2X will be fully warmed and will provide optimal performance after a minute of continuous heated cleaning. 4. Cleaning Strokes. While pressing the trigger, make one slow forward wet pass and another one back. Caution: Do not overwet. Take care not 4. to run over loose objects or edges of area rugs. Stalling brush may result in premature belt failure. Note: Your machine is equipped with a circuit breaker that will automatically shut off the brush if a large or loose object is caught in the brush roll. If that happens, be sure to unplug your machine, remove the foreign object, and then plug the machine back in to reset the circuit breaker. Release the trigger and make one slow forward and backward pass over the same area to remove any residual dirty water and aid in drying. Repeat cleaning passes until solution being pulled up appears clean. Continue passes without pressing the trigger until you can't see any more water being pulled up. Power Switch 5. Remove the tank from the base of the 5. machine by lifting up on the tank carry handle. Carry like a bucket to a utility sink or outside where you will dispose of the dirty water. a. Unlatch the top of the tank from the bottom by lifting up on the tank latch located on the back of the tank. b. Remove the top of the tank by lifting up on the handle. Note how the lip on the top tank separates from the groove in the bottom tank. This 5b. placement is important when putting the tank back together. c. Lift the bottom portion of the tank; pour out dirty water in the sink through the triangular shaped opening in the corner of the tank. Note: You may notice hair & debris deposits on the carpet or in the tank that were loosened by the cleaning action. This debris should be picked up and thrown away. Check the red lint filter inside the tank for debris and remove before 5d. continuing. d. Fill the heavy duty bladder with clean hot tap water and formula, following instructions 1c through 1e on page 7. Heater Switch 5a. 5c. www.bissell.com 8 800.237.7691