Bosch HGS7052UC Installation Instructions - Page 3

Important Safety Instructions Table of Contents Important Safety Instructions 1 Preparation ...3 Installation ...4 Final Steps ...5 Please read all instructions before using this appliance. Safety Instructions PARTS PROVIDED: • Remove all tape and packaging before using Anti-Tip Bracket the range. Destroy the carton and plastic bags after unpacking the range. Never allow children to TOOLS AND PARTS NEEDED: play with packaging material. • Standard Measuring Tape • Be sure your appliance is properly installed • Phillips Head Screwdriver and grounded by a qualified technician in • 1-1/4" Wrench accordance with the National Electrical Code ANSI/ • Pencil NFPA No. 7 latest edition and local electrical code • T-20 Torx Screwdriver requirements. • 3/8" Nut Driver Important: Local codes vary. Installation, • Screws (2) and Anchors (2) for Anti-tip Bracket electrical connections and grounding must comply (Style will vary depending on mounting surface) with all applicable codes. • Pipe Wrench (2) • Install only per installation instructions • Teflon® Tape* or Pipe Joint Compound included in the literature package for this (Appropriate for use with LP gas and Natural gas) range. • Channel Lock Pliers • Ask your dealer to recommend a qualified • Gas Leak Test Solution technician and an authorized repair service. • Level • Know how to disconnect the power to the • Drill and Drill Bit range at the circuit breaker or fuse box in and the • Gas Supply Line (Flexible Metal Appliance gas supply at the shutoff in case of an emergency. Connector or Rigid Pipe) • Do not repair or replace any part of the • Gas Shut Off Valve (If not already present) appliance unless specifically recommended • Gloves and Safety Goggles in the manuals. All other servicing should be * Teflon is a registered trademark of DuPont done by a qualified technician. This may reduce the risk of personal injury and damage to the WARNING: If the information in this manual is not followed exactly, a fire or explosion may result range. • When testing the supply piping system at test pressures in excess of 1/2 psig (3.5 kPa), the appliance and its indiviual shut-off causing property damage, personal injury or death. • Do not store or use combustible materials, gasoline or other valve must be disconnected from the gas piping system. • When testing the supply piping system at test pressures equal to or less than 1/2 psig (3.5 kPa), the appliance must be isolated flammable vapors and liquids in the from the gas supply piping system by vicinity of this or any other appliance. • WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch. • Do not use any phone in your closing its individual manual shut-off valve. • Never modify or alter the construction of a range by removing leveling legs, panels, wire covers, anti-tip brackets/screws, or any other part of the product. • Do not lift door by door handle. Remove the building. door for easier handling and installation. See • Immediately call your gas supplier from a neighbor's phone. Follow Section 'Removing Oven Door' in Use and Care manual. the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, authorized service agency or the gas supplier. English • 1