Bosch SHE43P02UC Use and Care Manual - Page 24

Refer to Clean the Door Gasket and Door - installation manual

Get Bosch SHE43P02UC - 24inch Evolution 500 Series Dishwasher PDF manuals and user guides
UPC - 825225875918
View all Bosch SHE43P02UC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Problem Dishes are not getting dry enough Odor Dishwasher not filling with water Water Leaks Tub stains 24 Cause Action 1. Rinse agent dispenser is empty. (Rinse agent indicator is activated). 2. Improper loading of dishes. 3. Selected cycle does not include drying. Note: Plastic or Teflon do not typically dry as completely as other items due to their inherent properties. 1. Add rinse agent. The use of rinse agent improves drying. 2. Rearrange load to ensure items are not nested. Refer also to the "Preparing and Loading" section of this manual. 3. Rinse and Hold setting does not include drying cycle, Note: Select models offer an extra heating options to improve drying performance. Refer to "Wash Cycle options" under the Operating the Dishwasher section of this manual. 1. Food debris is present at the bottom of the dishwasher. 2. Food particles are present near the door seal. 3. Dishes left too long in unit before running a cycle. 4. Residual water is present at the bottom of the dishwasher. 5. Drain hose is obstructed. 1. Remove the filters and clean according to the "ChecklClean the Filter System" section of this manual. 2. Refer to "Clean the Door Gasket and Door Seal" in the Care and Maintenance section of this manual. 3. Run a Rinse/Hold cycle if you do not intend to immediately wash the dishes. 4. Ensure the unit has completely drained from the last cycle. Refer to the "Canceling or changing the cycle" section of this manual. 5. Remove any obstructions from the drain hose by calling qualified personnel. Note: If odor still persists, run the Normal/Regular cycle until it flushes and interrupt the cycle and place an 8 oz. cup of distilled white vinegar solution on the top rack and then finish the cycle. 1. Restriction in the water supply system. 2. Previous wash cycle was not com- pleted. 3. Delay-start is active. 1. Suds 2. Door seal could be pulled away from track. 3. Condensation vent is blocked. 4. Improper installation. 1. Ensure that the water supply valve (typically located under kitchen sink) is open and check that the water supply line has no kinks and clogs. 2. Refer to the "Canceling or changing the cycle" section of this manual. 3. Cancel the delay-start or wait until delaystart time completes (times out). Refer to the "Delay Start" section of this manual. 1. Wrong type of detergent results in suds and leaks. Use only dishwasher detergents. If suds still persist, then add one tablespoon of vegetable oil at the bottom of the dishwasher and run the desired cycle. 2. Ensure that door seal is in the track. 3. Ensure that condensation vent is not blocked. Refer to "Loading Extra Tall Items" in the Preparing and Loading the Dishwasher section of this manual. 4. Have proper installation verified by qualified personnel (water supply, drain system, leveling, plumbing). 1. Stains on the dishwasher interior are due to hardness of water. 2. Silverware in contact with tub. 1. Concentrated Lemon juice can reduce the build up of hard water stains. Run a normal cycle until it flushes and interrupt the cycle and then place an 8 oz. cup of the concentrated lemon solution on the top rack and finish the cycle. This can be done periodically to avoid build up. 2. Ensure that the silverware does not make contact with the tub while running a cycle.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
Problem
Dishes
are not
getting
dry
enough
24
Odor
Dishwasher
not filling
with
water
Water
Leaks
Cause
1.
Rinse agent dispenser is empty.
(Rinse
agent indicator
is activated).
2.
Improper
loading of dishes.
3.
Selected cycle does not include drying.
Note: Plastic or Teflon do not typically
dry
as completely
as other items due to their
inherent
properties.
Tub stains
1.
Food debris is present at the bottom
of
the dishwasher.
2.
Food particles
are present near the
door seal.
3.
Dishes left too long in unit before run-
ning a cycle.
4.
Residual water is present at the bot-
tom of the dishwasher.
5.
Drain hose is obstructed.
1.
Restriction
in the water supply system.
2.
Previous wash cycle was not com-
pleted.
3.
Delay-start
is active.
1.
Suds
2.
Door seal could be pulled away from
track.
3.
Condensation
vent is blocked.
4.
Improper
installation.
1.
Stains on the dishwasher
interior
are
due to hardness of water.
2.
Silverware in contact
with tub.
Action
1.
Add rinse agent. The use of rinse agent im-
proves drying.
2.
Rearrange load to ensure items are not
nested. Refer also to the "Preparing and Load-
ing" section of this manual.
3.
Rinse and Hold setting does not include dry-
ing cycle,
Note: Select models offer an
extra
heating
op-
tions to improve drying
performance.
Refer to
"Wash Cycle
options"
under
the Operating
the
Dishwasher
section of this manual.
1.
Remove the filters and clean according to the
"ChecklClean the Filter System" section of this
manual.
2.
Refer to "Clean the Door Gasket and Door
Seal" in the Care and Maintenance
section of
this manual.
3.
Run a Rinse/Hold cycle if you do not intend to
immediately
wash the dishes.
4.
Ensure the unit has completely
drained from
the last cycle. Refer to the "Canceling or
changing
the cycle" section of this manual.
5.
Remove any obstructions
from the drain hose
by calling qualified
personnel.
Note: If odor still persists, run the Normal/Regular
cycle until it flushes
and
interrupt
the cycle and
place
an
8 oz. cup of distilled
white
vinegar solu-
tion on the top rack and then finish the cycle.
1.
Ensure that the water supply valve (typically
located under kitchen sink) is open and check
that the water supply line has no kinks and
clogs.
2.
Refer to the "Canceling or changing the cycle"
section of this manual.
3.
Cancel the delay-start
or wait
until delay-
start time
completes (times out).
Refer to the
"Delay Start" section of this manual.
1.
Wrong type of detergent
results in suds and
leaks. Use only dishwasher
detergents.
If
suds still persist, then add one tablespoon
of
vegetable
oil at the bottom
of the dishwasher
and run the desired cycle.
2.
Ensure that door seal is in the track.
3.
Ensure that condensation
vent is not blocked.
Refer to "Loading
Extra Tall Items"
in the Pre-
paring and Loading the Dishwasher
section
of this manual.
4.
Have proper installation
verified
by qualified
personnel
(water
supply, drain system, level-
ing, plumbing).
1.
Concentrated
Lemon juice can reduce the
build up of hard water stains. Run a normal
cycle until it flushes and interrupt
the cycle
and then place an 8 oz. cup of the concen-
trated lemon solution
on the top rack and
finish the cycle. This can be done periodically
to avoid build up.
2.
Ensure that the silverware
does not make
contact with
the tub while
running
a cycle.