Bosch SHX68E15UC Instructions for Use - Page 6

•Dishwasher setup Water softening system The dishwasher requires soft water to ensure proper washing results. Your appliance is equipped with an internal water softening system. However, if you have a household water softening system, you will not need to use this softening system. tap set value use water hardness at The required amount of salt depends on the degree of hardness of your ppm CaCO³/l dishwasher salt tap water (See table for more information). For the water softening system to function properly, it will need to use dishwasher water softener salt .The amount of salt dispensed can be set 0 - 110 120 - 140 150 - 180 H:00 H:01 H:02 no yes yes from "H:00" to " H:07". Salt is not required at H:00 (this is the default 190 - 210 H:03 yes factory setting). 220 - 290 H:04 yes • Open the door (for hidden controls only). 300 - 370 H:05 yes • Turn the unit on using the ON/OFF button . 380 - 540 H:06 yes • Hold down the "A" button and press START button until the display 550 - 890 H:07 yes indicates "H:00". Default setting from factory is H:00 • Release both buttons. • Press "B" to select the desired setting. To change the setting, • Press "C" button to select desired setting. • Save the selected language by pressing the START button. • Close the door (for hidden controls only). NOTE: For information on how to use the water hardness test strip, provided in the detergent sample kit, please see below. Using a water hardness test strip Establishing the water hardness Setting of Water Fill with Salt Dip the test strip briely into tap water for a secDoinpdb.rSiehflayktheeotfefsetxsctreipssinwtoattaepr wanatdercofomr opnaere after saepcpornodx,.s1hamkienuoftfee. xcess water compare after 1 min. adAAaridsefrfticteeaceoaorsrsllooo1wnwrraaiemliltltliimiososnnhhniunoootuoewwftfettyhtyhhtoeoheeueutretterthesehdetsdet ccoorrrreecctt sseettttiinngg.. Alignment of Softening Fill salt into the salt Unit container 0 0 no 1 0 no 2 2 yes 3 4 yes 4 6 yes 6