Bosch VDC-455V04-20S Installation Instructions - Page 11

FlexiDomeXT+ | Installation Manual Figure 4 Surface mounting - rear connection Solid surface (three pre-drilled 8mm holes) Conduit Wires EN | 11 Cap Three screws (supplied with camera) Three screws (M5, supplied) Surface mounting box (VDA-455SMB) Camera unit and base Surface mounting When using the raised mounting box: • With a side connection, remove the cap covering the side entrance. With a rear connection, leave the cap in place. • Attach the conduit to the mounting box. • Release the two clips at the bottom of the watertight connection compartment to remove it from the mounting box. • Open the cover of the watertight compartment in the mounting box by releasing the 5 clips. • Run the power and video wires through separate rubber grommets into the watertight compartment. • Run the cable from the camera into the watertight compartment through the supplied grommet. • Make the connection inside the watertight compartment and clip on the cover to seal it. Note In order to ensure a watertight cable entry, use round cables of between 5 and 6 mm (0.2 - 0.24 inches) for power and video connection. Use some silicon spray on the cable to help slide the grommets onto it. Bosch Security Systems | 2008-08 | V1.1