Bosch VDN-498V03-21 User Manual - Page 17
Surface mounting
View all Bosch VDN-498V03-21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
FlexiDome2X Installation | en 19 3.3.3 Surface mounting When using the surface mounting box: - With a side connection, remove the cap covering the side entrance. With a rear connection, leave the cap in place. - Attach the conduit to the mounting box. - Release the two clips at the bottom of the watertight connection compartment to remove it from the mounting box. - Open the cover of the watertight compartment in the mounting box by releasing the five clips. - Run the power and video cables through separate rubber grommets into the watertight compartment. - Run the cable from the camera into the watertight compartment through the supplied grommet. - Make the connection inside the watertight compartment and clip on the cover to seal it. Figure 3.5 Surface mounting box VDA-455SMB Note: To ensure a watertight cable entry, use round cables of between 5 and 6 mm (0.2 - 0.24 inches) for power and video connection. Note: Use some silicon spray on the cable to help slide the grommets onto it. Bosch Security Systems Installation Manual AR18-08-B010 | v1.0 | 2009.03