Bosch VJT-X10S Operation Manual - Page 79
iSCSI MSS Byte, Interface mode ETH 1
View all Bosch VJT-X10S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
VideoJet X10 i i Configuration Using a Web Browser | en 79 NOTICE! If you want to allow only secure connections with SSL encryption, you must select the Off option for each of the parameters HTTP browser port, RCP+ port 1756 and Telnet support. This deactivates all unsecured connections. Connections will then only be possible via the HTTPS port. You can activate and configure encryption of the media data (video, audio and metadata) on the Encryption page (see Section 5.42 Advanced Mode: Encryption, page 84). RCP+ port 1756 To exchange connection data, you can activate the unsecured RCP+ port 1756. If you want connection data to be transmitted only when encrypted, select the Off option to deactivate the port. Telnet support If you want to allow only secure connections with encrypted data transmission, you must select the Off option to deactivate Telnet support. The unit will then no longer be accessible using the Telnet protocol. Interface mode ETH 1 If necessary, select the Ethernet link type for interface ETH 1. Depending on the unit connected, it may be necessary to select a special operation type. Interface mode ETH 2 If necessary, select the Ethernet link type for interface ETH 2. Depending on the unit connected, it may be necessary to select a special operation type. Network MSS (Byte) You can set the maximum segment size for the IP packet's user data. This gives you the option to adjust the size of the data packets to the network environment and to optimize data transmission. Please comply with the MTU value of 1,514 bytes in UDP mode. iSCSI MSS (Byte) You can specify a higher MSS value for a connection to the iSCSI system than for the other data traffic via the network. The potential value depends on the network structure. A higher value is only useful if the iSCSI system is located in the same subnet as the VideoJet X10. Enable DynDNS DynDNS.org is a DNS hosting service that stores IP addresses in a database ready for use. It allows you to select the VideoJet X10 via the Internet using a host name, without having to know the current IP address of the unit. You can enable this service here. To do this, you must have an account with DynDNS.org and you must have registered the required host name for the unit on that site. NOTICE! Information about the service, registration process and available host names can be found at DynDNS.org. Host name Enter the host name registered on DynDNS.org for the VideoJet X10 here. User name Enter the user name you registered at DynDNS.org here. Bosch Security Systems Installation and Operating Manual DOC | V4.0 | 2009.06