Bosch WTB86200UC Instructions for Use - Page 15
Check heating system, Preparing to transport the dryer - step
View all Bosch WTB86200UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
To adjust the dryer feet: 1. Install the dryer on a level and solid surface, preferably in a corner of a room. 2. If the floor is uneven (or not level) adjust the dryer feet as required to level the dryer. Do not place anything under the dryer feet to help level the dryer. 3. Extend the dryer feet no more than is necessary. The more the feet are extended, the more vibration the dryer will experience. Start with the dryer feet turned all the way in and adjust each foot as necessary. 4. Use a bubble level to check the top of the dryer to make sure it is level side to side and front to rear. 5. Press down on each corner of the dryer top to make sure the dryer does not "wobble". There should be no "give" or movement. All four dryer feet should press equally against the floor. This is just as important as the dryer being level to prevent vibration. Preparing to transport the dryer - step by step 1. Rotate the program selector to Off. 2. Pull out power supply plug. 3. Place any accessories in the drum. 4. Close the door and secure with adhesive tape. 5. Screw the height-adjustable feet of the dryer into the housing to prevent them from being damaged during transportation. Check heating system 1. Check that the drum is empty. 2. Close the dryer door. 3. Switch the dryer to Extra Dry and then press the Start/Pause button. 4. After 3-5 minutes press the Start/Pause button and open the door. ▯ If the interior of the dryer feels warm, the dryer has been connected properly. Switch the dryer to Off. ▯ If the dryer does not work, switch the dryer to Off. Look in the Troubleshooting section of this user manual and find the fault. 15