Bosch WTB86200UC Instructions for Use - Page 29

Problem Possible cause(s) Solution(s) The Check drain indi- Drain hose is blocked. cator light up. Check drain hose. ~ Maintenance of drain hose; Page 27 Water has not drained completely. Check drain hose connection conditions. Drain hose is leaking: is not Check the drain hose, be sure that it is on the dryer screwed on the tight at both ends, securely with the clamp in place; may need to replace or rubber not placed in hose. the drain hose if leaking continues. Water is leaking out. Dryer is not leveled. Level the dryer. ~ Leveling the dryer; Page 14 The heat exchanger seal is dirty. Clean the heat exchanger seal. ~ Cleaning the heat exchanger; Page 26 Program terminates shortly after starting. Ambient temperature greater than Ventilate the room. 41°F/5°C. Laundry is not loaded. Load the laundry. ~ Loading the laundry; Page 23 Load too small for selected program. Use time program. ~ Program selection table; Page 18 Loaded laundry dry. Check the loaded laundry. If it is dry, open the door, remove laundry and turn program selector to Off. The door opens by itself. The door not closed properly. Close the door until a click is heard. Creasing. Laundry load exceeded. Unsuitable program selected. Do not exceed the maximum load for selected program. Remove items of laundry immediately after the end of the program, hang them up and pull into shape. Turn program selector to Off. ~ Program selection table; Page 18 Drying result is not sat- Warm laundry may feel damper Remove items of laundry immediately after the end of isfactory (laundry feels than it really is. the program and turn the program selector to Off. too damp). The selected program does not suit Use another drying program or, in addition, select the the load. time program. ~ Program selection table; Page 18 Dryness level is not adjusted. Use Dry Level to adjust the dryness level. ~ Dry Level; Page 19 Fine layer of limescale on the humidity sensors. Clean the moisture sensors. ~ Cleaning the moisture sensors; Page 27 Program termination e.g. main See the problem(s) mentioned in this table. power supply failure, door open or maximum drying time reached. Laundry is too wet. Spin laundry at higher speed in the washing machine, before drying. Switch off the dryer and switch on again. Drying time too long. Lint filter is dirty. Clean lint filter. ~ Cleaning the lint filter; Page 25 Insufficient supply of air. Ensure that air can circulate. Air inlet possibly blocked. Do not obstruct the air inlet on the front of the dryer. Ambient temperature higher than Ventilate the room. 95°F/35°C. Program does not start Program ending time has been Finished in (remaining) selected and activated. time is displayed. Drying cycle will begin at proper time to complete at the selected Finished in time. Program does not start Childproof look is activated. - D symbol light up. Deactivate Childproof look. ~ Childproof lock; Page 24 29