Bosch WTB86200UC Instructions for Use - Page 24

▯ If Check drain indicator lights up, check the drain hose and its connection. ~ Maintenance of drain hose; Page 27 3. If required, select Low Heat by pressing the button. ~ Additional options; Page 19 4. If required, select Wrinkle Block by pressing the button. ~ Additional options; Page 19 Tip: The estimated remaining time will be updated. Indicator of program sequence The dryer uses an electronic control system. A moisture sensor continuously checks the moisture in the laundry. Drying ends automatically as soon as the selected degree of dryness has been reached. The drum continues to rotate at specific intervals for one hour to prevent creasing. The current state of the process and level reached during the program sequence is indicated by indicator lights (dry, damp, regular). Selecting a different program If you have inadvertently started the wrong program, you can change this as follows: 1. Press Start/Pause. 2. Select another program. 3. Press Start/Pause. The new drying cycle starts from the beginning. Cancel program If required, you can cancel the selected program: 1. Press Start/Pause. 2. Rotate the program selector to Off. Program end Childproof lock You can secure the dryer against inadvertent changing of the set functions. To do this, activate the childproof lock after cycle start. To Activate/Deactivate, press Start/Pause for approx. 5 seconds. In the display field, you will see the D symbol light indicating the childproof lock is active. NOTICE: The childproof lock will remain activated until the next cycle start even after switching the machine off. You must deactivate the childproof lock before the next cycle and, if necessary, activate it again after starting the cycle. End appears in the display area, the Start/Pause button indicator lamp is off and the regular indicator lights up. After the program end, rotate the program selector to Off. Removing laundry/switching the appliance off 1. Open the door and remove the laundry. 2. Turn the program selector to the Off position. Appliance is switched off and dryer light goes out. 3. Clean lint filter. ~ Cleaning the lint filter; Page 25 4. Close the door. Tip: If at the end of the drying cycle the display does not light, the energy-saving mode is active. To see diplay, e.g. press any button. ~ Environmentally friendly use of your dryer; Page 7 Signal For switching the buzzer on and off press the Signal button. The Buzzer indicates program end if it is activated. Other alarms are not influenced by this option. 24