Bosch WTB86200UC Instructions for Use - Page 19

Program settings At the factory initial settings are pre-set for all cycles. You can change some program settings as follows. Time Dry Available only for Time programs, ~ Program selection table; Page 18 can be selected from minimum 20 minutes to maximum 3 hours, in 10-minute steps. Dry Level The dryness levels (e.g. Cotton Dry) can be increased in 3 levels. The laundry is made drier. Default setting = 0. Selectable values: 0, 1, 2, 3. After setting the Dry Level for a program, it is also retained for other programs, until it is changed again. Finished in Before the program start, the program end (Finished in time) can be pre-selected in one-hour steps up to a maximum of 24 h (h=hour). Press the Finished in button until the desired setting is displayed. NOTICE: The cycle duration is included in the set Finished in time. After the start, the pre-selected drying time, e.g. 8 h is displayed and counted down until the drying cycle begins. Then the cycle duration, e.g. 2:30 (hours:minutes) is displayed. Additional options Low Heat Reduced temperature for delicate fabrics, e.g. polyacrylic, polyamide or elastane, with longer drying time. Observe the care information or symbols on the textiles tickets. Wrinkle Block To prevent the laundry from creasing, the dryer drum rotates at specific intervals following the drying program. Standard setting for this function is 1 hour. If the Wrinkle Block button is pressed, this function is extended to 2 hours. The laundry remains loose and fluffy until it is removed. The laundry should be removed at the latest after this time has elapsed. 19