Bosch WTMC5521UC Operating, Care, Installation (all languages) - Page 21

Degree of drying has not been reached Moisture sensor dirty. or the drying time is too long. Display may indicate E:03". Exhaust air duct is blocked or too long. Lint filter dirty. Laundry was too wet. Unsuitable program selected. Maximum drying time was exceeded. Motor limit temperature was exceeded. Drum light does not function. No program selected. Light bulb defective, light bulb burned out. No power supply. Ligfht bulb is loose. Start/Stop" indicator light does not illuminate Wrinkle block" indicator lights. The display shows 000". Lint filter LED is blinking after lint filter has been cleaned Fault in program sequence or malfunction. Blinking of lint filter LED is not an indication of a problem. It is used only as a reminder. Clean moisture sensor as described on page 19. Switch off/switch on again. Clean exhaust air extraction. Reduce exhaust air duct to maximum length as described on page 7 Switch off/switch on again. Clean filter as described on page 19. Switch off/switch on again. Spin laundry at higher speed in the washing machine. Switch off/switch on again. Select program with aid of the program selection table (see page 19). Switch off/switch on again. Clean lint filter (see page 19). Check exhaust air extraction. Spin laundry at a higher speed in your washer. Switch off dryer, leave to cool down for 30 min. Switch on again. Start program. Select program. Change light bulb, see page 20. Guarantee power supply. Tighten light bulb. Remove and reinstall the cover as directed on page 20. Switch off dryer, leave to cool down for 30 min, switch on again. Restart program. No action required. Light will stop blinking. SERVICE and REPAIR d CAUTION CAUTION - Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. verify proper operation after servicing. The Bosch dryers require no special care other than the care and cleaning noted above. i If you are having a problem with your dryer, before calling for service please refer to Table on page 20, following. If service becomes necessary, contact your dealer or installer or an authorized service center. Do not attempt to repair the appliance yourself. Any work performed by unauthorized personnel may void the warranty. If you are having a problem with your Bosch dryer and are not pleased with the service you have received: - First, please contact your installer or the Bosch Authorized Service Contractor in your area and explain to them why you are not satisfied. This will usually correct the problem. - If after working with your installer or service person the problem still has not been resolved to your satisfaction, please let us know by either writing to us at, BSH Home Appliances 5551 McFadden Avenue Huntington Beach, CA 92649 or, calling us at 1Ć800Ć944Ć2904. Please be sure to include, if writing, or have available, if calling, the following information: - Model Number - Serial Number - Date of Original Purchase - Date Problem Originated - Explanation of Problem Also, if writing, please be sure to include a daytime telephone number and a copy of the sales invoice. You will find the model number and serial number information on the rating plate located on the inside of the front panel. 21