Bose Acoustimass 700 Owner's guide - Page 8

Connect, speakers

Page 8 highlights

SettingUp Acoustimass' module Bose' recommends putting your Acoustimass module at the same end of the room as the television monitor. To prevent interference, keep the module at least 2 feet (.6 m) from the • television. • You may hide the Acoustimass module behind or under furniture, but do not block the opening. Be sure there is at least 2 inches (5 cm) between the opening and any surface. • If the opening faces the wall it increases the bass; if it faces away it decreases the bass. For the most bass response. position the opening 2 to 3 inches (5 to 8 cm) from a wall or corner. • Stand the Acoustimass module vertically or horizontally (Figure 7). After selecting a place for the Acoustimass module, attach the larger set of four rubber feet to the bottom surface for additional stability. The feet also protect the cable connections if the Acoustimass module is standing on the end that has the cable connections. Figure 7 Acoustimass module positions C 0 • Connect the speakers Use the supplied 20-foot speaker cables to connect the cube speakers to the Acoustimass module and the module to your receiver. Use the 50-foot cables to connect the surround speakers to your receiver. Note: If you need longer speaker cables, splice in 18-gauge (0.75 mm) or thicker cable. Make sure to attach the wires positive to positive and negative to negative. Speaker cable consists of two insulated wires. The insulation around one wire is marked with a red band. This wire is always positive (+). The plain wire is always negative (-). These correspond to the positive (red) and negative (black) terminals on the back of each speaker or receiver. Be sure to connect each wire to the proper terminal, positive to positive and negative to negative. CAUTION: Before making any connections, turn off your receiver and unplug it from the AC power (mains) outlet. Not doing so may result in damage to your system. • 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22

Setting
Up
Acoustimass'
module
Bose'
recommends
putting
your
Acoustimass
module
at
the
same
end
of
the
room
as
the
television
monitor.
To
prevent
interference,
keep
the
module
at
least
2
feet
(.6
m)
from
the
television.
You
may
hide
the
Acoustimass
module
behind
or
under
furniture,
but
do
not
block
the
opening.
Be
sure
there
is
at
least
2
inches
(5
cm)
between
the
opening
and
any
surface.
If
the
opening
faces
the
wall
it
increases
the
bass;
if
it
faces
away
it
decreases
the
bass.
For
the
most
bass
response.
position
the
opening
2
to
3
inches
(5
to
8
cm)
from
a
wall
or
corner.
Stand
the
Acoustimass
module
vertically
or
horizontally
(Figure
7).
After
selecting
a
place
for
the
Acoustimass
module,
attach
the
larger
set
of
four
rubber
feet
to
the
bottom
surface
for
additional
stability.
The
feet
also
protect
the
cable
connections
if
the
Acoustimass
module
is
standing
on
the
end
that
has
the
cable
connections.
C
Connect
the
speakers
0
Use
the
supplied
20
-foot
speaker
cables
to
connect
the
cube
speakers
to
the
Acoustimass
module
and
the
module
to
your
receiver.
Use
the
50
-foot
cables
to
connect
the
surround
speakers
to
your
receiver.
Note:
If
you
need
longer
speaker
cables,
splice
in
18
-gauge
(0.75
mm)
or
thicker
cable.
Make
sure
to
attach
the
wires
positive
to
positive
and
negative
to
negative.
Speaker
cable
consists
of
two
insulated
wires.
The
insulation
around
one
wire
is
marked
with
a
red
band.
This
wire
is
always
positive
(+).
The
plain
wire
is
always
negative
(-).
These
correspond
to
the
positive
(red)
and
negative
(black)
terminals
on
the
back
of
each
speaker
or
receiver.
Be
sure
to
connect
each
wire
to
the
proper
terminal,
positive
to
positive
and
negative
to
negative.
Figure
7
Acoustimass
module
positions
CAUTION:
Before
making
any
connec-
tions,
turn
off
your
receiver
and
unplug
it
from
the
AC
power
(mains)
outlet.
Not
doing
so
may
result
in
dam-
age
to
your
system.
8