Bowflex Blaze Assembly Manual - Page 12

Assembly Guide Step 9 - Attach the Seat Rail to the Main Assembly Locate the following items: • From Step 4 - Main Assembly • From Step 8 - Seat Rail Assembly • Item #12 - Seat Rail Knob • Item #J - (1) 3/8" X 4 1/4" Button Head Screw • Item #N - (2) 3/8" Washers • Item #O - (1) 3/8" Nylock Nut • Item #Q - (1) Bolt Cover Align the holes on the Seat Rail Assembly (from Step 8) with the holes in the Rail Bracket on the Main Assembly (from Step 4), as shown in Figure 9. Figure 9 Main Assembly Seat Rail Bracket 12 J Rail Assembly Insert the Seat Rail Assembly into the Seat Rail Bracket, and then place (1) 3/8" Washer (Item #N) over the end of (1) 3/8" X 4 1/4" Button Head Screw (Item #J). Insert the screw through the aligned holes, as shown, and place (1) 3/8" Washer and (1) 3/8" Nylock Nut (Item #O) over the end of the screw to secure. O N Do not over-tighten the hardware from Step 9. Note: Tighten the nylock nut enough that the threads of the screw extend through the nylock nut, but loosely enough that the Seat Rail Assembly can move freely. At this time, place (1) Bolt Cover (Item #Q) over the Nylock Nut installed during Step 9. Then, thread the Seat Rail Knob (Item #12) into the top hole on the Seat Rail Bracket, as shown in Figure 9, but do not over-tighten. 10