Bowflex Blaze Assembly Manual - Page 22

Assembly Guide Step 26 - Route the Lat Cables Locate the following items: • Item #S- (2) Hand Grips • Item #R- (1) Bent lat Bar (optional) • Item #Z- (2) Lat Cableswith (2) Snap Hooks (attached) Unwrap the Lat Cables with Snap Hooks from both pulleys on the Lat Cross Bar. Pull one end if the cables down from the Lat Cross Bar and fasten to Chest Cable Snap Hook. Fasten attached Snap Hook from the Lat Cable to a Hand Grip or the bent Lat Bar. Repeat for remaining Lat Cable. Figure 26- Lat Cables Snap Hook Hand Grips or Bent Lat Bar Snap Hook Step 27 - Route the Leg Cables Locate the following items: • Item #AA - Leg Cable • From Step 14 - Leg Extension Seat Assembly Unwrap the Cables from the Rear Leg Pulley. Pull one end of the "Y" Cable away from the Rear Leg to fasten to a Snap Hook on the Rod Cable. Note: For this step, make sure your Leg Extension Seat is installed. Figure 27 - Leg Cables Snap Hook Leg Extension Seat Step 28 - Route the Squat Cables Locate the following items: • Item #R - Squat Bar Figure 28 - Squat Cables Squat Bar Unwrap the Cables on each Base Leg Pulley. Pull one end of the Cable up from the Leg Pulley, and fasten the Cable to a Snap Hook on the Chest Bar. Fasten the Snap Hook attached to the Squat Cables to the corresponding Squat Bar "D" Ring. Repeat for remaining Squat Cable. CONGRATULATIONS! You have successfully completed assembly of your Bowflex® Blaze™ Home Gym! Please inspect your machine to ensure that all fasteners are tight and everything is properly assembled. Review all warnings that are affixed to the machine. 20 Snap Hook Snap Hook